Shut Down Procedure - CASTLE HPS10 Manual Del Operador

ShuT DOwN pROCeDuRe

Press the button on the control pad to initiate the shut
I
down mode. Once this is done the auger will stop feeding
pellets, but the room air distribution blower and exhaust fan
will continue to operate. When the internal temperature of
the unit drops below the factory preset temperature, the
room air distribution blower and exhaust fan will cease to
operate and the unit will be completely shut down.
Shut down times will vary.
CONTROl pAD key - See fIguRe 12
1. On/Off Button - Starts and stops operation of stove.
. Level Adjustment Button - Adjusts heat range levels
to low, medium, high.
. Power Indicator - Illuminates when the main power
switch is on. See fIguRe 10.
. Fault Indicator - Illuminates when stove is
overtemped or if there is loss of fire during startup
or during normal operation.
See TROubleShOOTINg SeCTION.
. Auto Ignition Indicator - Illuminates when igniter is
operating.
. Fuel Feed Indicator - Illuminates when the feed
auger is operating.
. Exhaust Blower Indicator - Illuminates when exhaust
blower is operating.
. Room Air Blower Indicator - Illuminates when room
air blower is operating.
Note: room air blower will not operate until stove
has reached factory preset operating temperature.
9. Heat Level Indicator - Narrow right hand bar is low
(C). Middle bar is medium (B). Lett hand bar is high
(A). The light is only on each bar alone, not all three.
3 4
Figure 13: Control pad key
5 6 7
1
Check for parts online at www.castlestoves.com or call 800-345-6007 M-F 8-5 CST
WARNINg
NeveR ShuT The STOve DOwN by uNplug-
gINg IT fROm The pOweR SOuRCe.
NeveR ShuT The STOve DOwN by SwITCh-
INg Off The mAIN pOweR SwITCh ON The
ReAR Of The STOve.
NeveR OpeN SIDe pANelS OR mAIN DOOR
wheN STOve IS IN OpeRATION.
NeveR TOuCh glASS DOOR AND ASh pAN
lATCheS whIle IN OpeRATION, They geT
exTRemely hOT AND wIll buRN yOu.
Figure 12: Control pad location
8
9
A
b C
2
Operator's Manual
HPS10 Pellet Stove
1