TEFAL FV4493 Manual página 21

If there is a problem?
PROBLEM POSSIBLE CAUSE
Water drips from the The chosen temperature is too
holes in the soleplate. low and does not allow for the
formation of steam.
You are using steam while the iron
is not hot enough.
You are using the Shot of Steam
button too often.
There is too much steam.
You have stored the iron horizon-
tally, without emptying it and
without setting it to
The iron drips You have removed the anti-scale
when you start ironing. rod to fill your iron.
Brown streaks come You are using chemical descaling
through the holes in the agents.
soleplate and stain the You are not using the right type of
linen. water.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
The soleplate is dirty or Your are ironing with an inappro-
brown and can stain the priate program (temperature too
linen. high).
You are using starch.
There is little or no The water tank is empty.
steam. The anti-calc valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for too
long.
The soleplate is scrat- You have placed your iron flat on a
ched or damaged. metallic rest-plate or ironed over a
zip.
Steam or water come The steam control is not set to the
from the iron as you
finish filling the tank. The water tank is overfilled.
The spray does not The water tank is not filled enough. Fill up the water tank.
spray.
If you have any problem or queries, please contact our
Customer Relations team first for expert help and advice.
.
position.
0845 602 1454 - UK / (01) 677 4003 - ROI
SOLUTION
Position the thermostat in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of the
button.
Reduce the steam.
See the section "Storing your iron".
Do not extract the anticalc valve when filling
the iron.
Do not add any descaling agents to the water
in the water tank.
Perform a self-cleaning operation and consult
the chapter "What water should I use?".
Perform the self-cleaning operation and clean
the soleplate with a damp sponge. Vacuum
the holes of the soleplate from time to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits of
soap or chemical products on new clothes.
Clean the soleplate as indicated above. Select
the appropriate program.
Clean the soleplate as indicated above.
Always spray starch onto the reverse side of
the fabric to be ironed.
Fill it.
Clean the anti-calc valve.
Clean the anti-calc valve and carry out a self-
clean.
Carry out a self-clean.
Always set your iron on its heel.
Do not iron over zips.
Check that the steam control is set to the
position.
Never exceed the Max level.
EN
DE
FR
NL
IT
ES
PT
DK
NO
SV
FI
EL
CZ
HU
SK
HR
SL
RO
SR
BG
PL
TR
UK
ET
LV
LT
RU
HK
RC
TH
KO
21