Remote Control Display - Toshiba RBC-SR1-PE Manual Del Usuario

All manuals and user guides at all-guides.com
AI R
EMOTE
R C
EMOTE
All of the display items are shown in the diagram below for the purpose of explanation. Only selected
items are displayed in actual operation.
2 3
1
MODE FAN CENTRAL
FAN ONLY AUTO OPERATION
COOL HIGH STANDBY
9
MED PREHEAT
HEAT LOW DEFROST
AUTO FILTER
11
TEMP CHECK LOUVER
UNIT MANUAL
10
˚ C
88
12
TIMER CONT. OFF ON ADDRESS
13 88 : 88
H M
14
1. MODE Display
Displays selected operation mode.
2. FAN Display
Displays selected fan speed mode.
3. CENTRAL Display
This is displayed if air conditioner operation is
being restricted by the central remote controller.
If "central" is flashing, the air conditioner is
locked in the "off" position by the central remote
controller.
4. OPERATION Display
This is displayed during the air conditioner
operation.
5. STANDBY Display
This is displayed if the air conditioner is
connected to a super multi system when
operation is being disabled.
6. PRE HEAT DEFROST Display
This display appears at the start of the heating
operation or during the defrost operation.
7. FILTER Display
This display appears after 2500 hrs of operation.
GB
C
ONTROLLER
D
ONTROL ISPLAY
4 5 6 7
NETWORK
REMOTE CONTROLLER
8
MODE
- +
TIMER ADJUST
CHECK FILTER
ON/OFF
8. LOUVER or LOUVER MANUAL Display
"Louver" is displayed if the automatic louvers are
driven. "Louver manual" is displayed if "auto
louver" is selected but not available.
9. CHECK Display
This display appears when the air conditioner is
in the "check" mode.
10.UNIT Display
This is used in the "check" mode.
11.TEMP Display
This display shows the set temperature.
12.TIMER Display
If the lapse timer is selected for "on" or "off". If
the timer is reset to "continuous", this is
displayed, then disappears.
13.TIME OR CHECK Display
This display shows the time remaining to "on/off"
for the timer or the inspection code.
14.ADDRESS Display
When LAN addresses are set, this
is displayed.
– 4 –