Publicidad
Idiomas disponibles
Idiomas disponibles
• DO NOT place this product near a window where cords from blinds or curtains
could strangle a child
• All assembly fittings should always be tightened properly
• not to use seating if any part is broken, torn or missing and use only spare parts
approved by the manufacturer
• the restraint system shall be removed/hidden/covered when the product is used as
a seating
Highchair for babies
This product is intended for babies between the ages of 24 and 60 months, weighing up to 20
kg, who are able to sit up unaided.
Essential parts
1. Seat with seat belts attached
2. Front upper legs with threaded holes x2
3. Rear upper legs x2
4. Lower legs x4
5. Tray with plastic cover
6. Footrest
7. Screws (for footrest assembly) x2
8. Armrests x2
Assembly
Screw the front upper legs with the threaded holes (2) into the holes in the front of the seat (1)
(Figures I and II). Make sure the holes in the legs are in the front. Screw the footrest (6) to the
legs using the screws (7) supplied. Follow the instructions shown in figures III, IV and V. Then
screw the rear upper legs (3) into the holes at the back of the seat (1) (Figures VI and VII). Tighten
the front and rear lower legs (4) (Fig. VIII). Adjust the white pads at the end of the lower legs so
that the whole slanted plane is adjacent to the floor (fig. IX). To install the tray (5), slide it into
the guides while pressing the button at the front of the tray (fig. X).
Mounting and adjustment of the tray
To mount the tray, slide it into the guides while pressing the button on the front of the tray. To
adjust the tray, press the button and then select the desired distance (fig. XII).
The tray has a removable plastic insert (fig. XIII) and a safety device.
21
Publicidad
