Power On/Off - Lenco PDR-011 Manual De Usuario

POWER SUPPLY/BATTERY
Connect the micro USB charging cable to the DC 5V input jack on the radio.
Connect the other side of the micro-USB cable to the power source using a USB power supply. It
is also possible to recharge the product by connecting it to the USB port of a computer. The radio
should fully recharge in about 3 hours (charging times may vary depending on the state of
charge of the battery).
When the unit is in Standby the display shows the date and time (if the option is active and the
unit has been used on a source that transmits this information) and the charge status.
NOTE: nothing is shown on the product display when it is charging from off but charging takes
place regularly.

POWER ON/OFF

Connect the headphones with 3.5mm jack to the headphone output. The product uses
headphones as an antenna to improve signal reception.
Turn the Power switch to the "On" position to turn on the product. The first time it is turned on,
DAB mode is activated and the stations are automatically scanned.
8