Safety Instructions - Pentair MYERS SRM4 Serie Manual De Instalación Y Funcionamiento

SAFETY INSTRUCTIONS

IMPORTANT
SAVE THESE INSTRUCTIONS: This manual contains important
instructions that should be followed during installation,
operation, and maintenance of the product. Carefully read and
follow all safety instructions in this manual.
Indicates a hazard which, if not avoided, will result
in death or serious injury.
Indicates a hazard which, if not avoided, can result
in death or serious injury.
Indicates a hazard which, if not avoided, can or
may result in minor or moderate injury.
NOTE: Addresses practices not related to personal injury.
SAFETY INSTRUCTIONS
Hazardous Voltage. Can cause severe or

fatal electrical shock. Do not plug in or unplug while
standing on a wet floor or in water. Failure to follow this
warning can result in fatal electrical shock.
Risk of electrical shock. Do not lift the pump

by the electrical cord; lift pump only by the discharge pipe,
lifting ring or handle on the pump. Lifting by the cord can
damage the cord.
Do not smoke or use devices that can generate sparks in a

septic (gaseous) environment.
Disconnect power to outlet box before unplugging pump.

Take extreme care when changing fuses. Do not stand in

water or put your finger in the fuse socket.
Be sure that construction and access to septic sumps

conform with all OSHA requirements.
Do not run the pump dry. Dry running can overheat the

pump, (causing burns to anyone handling it) and will void the
warranty.
The pump normally runs hot. To avoid burns when servicing

pump, allow it to cool for 20 minutes after shutdown before
handling it.
The pump is permanently lubricated. No oiling or greasing is

required in normal operation. For overhaul, see instructions
under "Service".
Vent sewage or septic tank according to local codes.

This unit is not designed for applications involving salt

water or brine! Use with salt water or brine will void
warranty.
MY13800A991 (01-01-22)
ELECTRICAL
DO NOT splice the electrical power cord. Do not modify

the cord and plug. When using the cord and plug, plug into
a grounded outlet only. When wiring to a system control,
connect the pump ground lead to the system ground.
DO NOT allow the electrical cord plug to be submerged.

DO NOT use extension cords. They are a fire hazard and

can reduce voltage sufficiently to prevent pumping and/or
damage motor.
DO NOT handle or service the pump while it is connected to

the power supply.
DO NOT remove the grounding prong from the plug or

modify the plug. To protect against electrical shock,
the power cord is a three-wire conductor and includes
a 3-prong grounded plug. Plug the pump into a 3-wire,
grounded, grounding-type receptacle. Connect the pump
according to the NEC or CEC and local codes.
DO NOT install pump in any location classified as hazardous

by National Electrical Code, ANSI/NFPA or the Canadian
Electrical Code.
For automatic operation, plug or wire the pump into an

automatic float switch or duplex controller. The pump will
run continuously when plugged directly into an electrical
outlet.
Connect or wire pump to its own individual branch circuit

with no other outlets or equipment in the circuit. Size fuses
or circuit breakers according to the "Specifications" list.
Risk of electrical shock and fire. Can burn,

kill or cause property damage. Be sure that power supply
information (Voltage/ Hertz/Phase) on pump motor
nameplate matches incoming power supply exactly.
Install pump according to all electrical codes that apply.

CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
3