Introduction; Using An Hvlp Spray System - Titan CS105 Manual De Propietario

CS105
2

introduction

This High Volume/Low Pressure (HVLP) spray system is designed
for applying coatings to surfaces that can be sprayed faster
than brushing or rolling and are too small for traditional airless
sprayers. Components of this system include a power switch, a
power cord, a filter warning light, a circuit breaker switch, a dual
filtration system, a cup holder, an air hose, and an air outlet.
The turbine is also equipped with a tool box. It is located on the
reverse side of the turbine and can be used to store projector
sets or any other small spare parts.
1
2
3
1. Circuit breaker switch
2. Filter warning light
3. Filter
4. Air inlet
5. Cup holder
6. Filter (in the end of can)
7. Power switch
8. Air outlet
* Air hose not pictured.
With this HVLP spray system, you can achieve the highest
quality professional finish possible with little or no preparation
or setup time. Please review all the information contained in
this manual before operating the system.
3

uSing an hvlp Spray SySteM

Refer to the following information to operate and
i
understand your HVLP spray system.
Your system may include a short air ("whip")
i
hose. The short hose should be connected to the
longer hose or a remote spraying system (sold
separately) and NOT directly to the turbine. See
your spray gun instruction manual for complete
instructions.
4
1
5
6
7
8
1. Turbine
2. Air hose
3. Whip hose
4. Coupling
5. Spray gun
Do not attach the short air whip hose directly to
the turbine, as the hose will become damaged.
Attention
introduction / using an HVlp spray system
5
4
2 3
5