Work Light; Travel Lock - NORAUTO 2207763/NO6701 Instrucciones De Uso

4. When the load current exceeds 2.4A, the USB output will be automatically turned off.
5. The charging time will be more than 8 hours, and the USB output will be automatically turned off.

4.5 Work light

1. Press and hold the "POWER" button (7) over 3 seconds to turn it on.
2. Lighting (2) working mode:
Turning ON: 100% brightness
1st short press: 50% dim light
2nd short press: Slow flash
3rd short press: Flash
4th short press: SOS
5th short press: Close
3. After continuing to work for more than 5 seconds in any working mode, short press the "POWER"
button (7) will turn off the light directly.

4.6 Travel lock

1. Press and hold the "POWER" button (7) over 8 seconds to turn on the travel lock mode.
2. In this mode, the device will fall into sleep (lock state): short press the "POWER" button (7) would not
turn on the USB output, work light output or 12V output.
3. To turn off the "travel lock" mode: Press and hold the "POWER" button (7) again for over 8 seconds to
release the device.
5. Packaging
SN Accessories
1
2 Smart Clamps
3 Male Cigarette Lighter
6. Q&A
1. Q. Why didn't my Jump starter start my vehicle?
A. There could be a number of reasons why the Jump starter did not start your vehicle.
Check the following:
1. Ensure the Jump starter battery is fully charged.
2. Ensure you have followed the correct operating procedure. Refer to Operation 4.3.
3. Ensure the vehicle operates on 12V DC.
4. Ensure the displacement of the car is not bigger than 4L.
5. The vehicle's battery may be below 2.5V, the minimum start voltage for the Jump starter. Ensure
all connections are correct, then press the Power/Light and Jumpstart buttons simultaneously
for 3 seconds to manually activate the Jump starter. (This is optional and various according to
product.)
2. Q. Can I leave my Jump starter connected to the car after it has started?
A. Leaving the Jump starter connected to the car after it has started will not be a problem. But it is
best to disconnect and charge the Jump starter so it is ready to start another car. As the Jump starter
will not be receiving charge in this situation and it is best to pack the Jump starter away so it will not
fall in the engine area.
3. Q. What is Peak Amps?
A. Peak amps is the maximum current the battery in the Jump starter can produce.
4. Q. What is Cranking Amps?
A. Cranking Amps is the continuous current available during jump starting.
5. Q. How do I turn off the product?
A. The product has intelligent detection function. If there is no load, or the electronic product is
charged for long time, the device will automatically fall into "sleep" and save the energy.
Note: The engine start port on the device is always live and is protected with rubber cover.
Adaptor
Qty SN
1 4
1 5
1
80
Accessories
Manual
Zipper Pouch
Qty
1
1