Operation; Initial Check Before Start; Starting The Machine; Stopping Machine - HOLZMANN MASCHINEN TKS500S Instrucciones De Servicio

16

OPERATION

16.1 Initial check before start

 Check that the max. speed of the machine is lower than the max. permissible speed of the
used saw blade and direction is correct.
 Use only sawblades with a diameter of between 450 and 500mm.
 The riving knife is correctly adjusted.
 Saw blade is not damaged.
 All guards are fitted and in proper condition.
 If necessary, check whether the connection to a dust collection system is available.
The guards must not be manipulated; in particular, the self-closing mechanism of
saw blade guards must not be blocked (e.g. by using keys).
16.2 Operation

16.2.1 Starting the machine

1. Starting saw blade movement by pressing button (1)

16.2.2 Stopping machine

Normal stop:
Press the OFF-button (2). Both blades stop movement.
16.3 Notes on using the table saw
16.3.1

Longitudinal cuts

When performing this operation, the following equipment shall be used for safe working:
 Rip-fence
 the guard of the saw blade
 the riving knife
 the insert in the table
 push stick when cutting small workpieces (distance between saw blade and fence
<120mm) and rip-fence with small
When cross-cutting round timber, a template or a holding device is necessary to se-
cure the workpiece against twisting and the use of a suitable saw blade is necessary.
HOLZMANN MASCHINEN GmbH
WARNING
NOTICE
www.holzmann-maschinen.at
OPERATION
32
TKS500S