Additional Programming Sequence - Dascom Tally T2150S Guia De Instalacion

Cutter-en.book Seite 16 Donnerstag, 3. Mai 2007 9:42 09

Additional programming sequence

Additional programming sequence
16
All manuals and user guides at all-guides.com
With the cut device installed, an escape sequence for cutting at the current line is
available in addition to the programming sequences described in the optionally
available Programming Manual.
Data structure
ASCII ESC ,,[ <n>
hex 1B 5B n
dec. 27 91 n
Parameters
For the ESC [ n { function, the following parameters are available for n:
n hex. dez.
0 30 48
5 35 53
6 36 54
7 37 55
22 32 32 50 50
50 35 30 53 48
51 35 31 53 49
54 35 34 53 52
* Above the line if the text to be printed ends with a CR (hex. 0D, dec. 13).
Below the line if the text to be printed ends with a LF (hex. 0A, dec. 10).
Cutting single sheets is not possible. Refer to the programming manuals for more
details on the programming sequences.
,,{
7B
123
Paper source and cut
Single sheet (manually)
Fanfold paper tractor 1
Fanfold paper tractor 2
Fanfold paper tractor 3
Fanfold paper ASF-F
Return sheet to the printing position
Cut fanfold paper at next perforation
Cut above/below the current line*
Quick start guide