Master MT Dry 800 Manual De Uso Y Mantenimiento página 31

Finally, extract the brush by holding it at both ends and pulling it perpendicular to the supports as shown in the following image. The
7
brush will come free and can be cleaned separately.
Once all the previous actions have been carried out the remains of raw material present in the equipment can be removed using a hydro-
8
cleaning machine. It is important to pay special attention to the following components:
• Electrical components
• Control panel
• Sensors, LEDs
• Bearings, etc.
which must not be sprayed directly or under pressure with water because they are sensitive and can be damaged by possible impacts.
Once the cleaning process is finished and the parts are completely dry, reverse the previous steps to reassemble the
9
machine. Firstly, mount the brush by grasping it at both ends and insert it into the supports, exerting perpendicular
pressure.
Then, place the metal part of the blade on top of the lower shaft and assemble the hooks of the elastic tensioning
10
straps in the horizontal slots on the upper part of the blade.
www.masterproducts.es
31