Ex-Cell ETS1 Manual De Instrucciones página 6

Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to
compensate for unusually long air hoses (over 25 feet). Minimum hose diameter
should be 3/8" I.D. and fittings should have 1/4" NPT thread.
Operation
Before each use:
l
Drain water from air
compressor tank and con-
densation from air lines. See
air compressor's operators
manual.
Disconnect the tool from
the air supply before
lubricating or changing
sandpaper disc.
l
Lubricate tool, see "Maintenance" section in this manual.
IMPORTANT: The tool MUST be in the lock position to install sandpaper
pad.
l
Rotate drive cylinder lock (A) until the ribbed edges connect with the drive
cylinder (B) and stops.
l
Hold drive cylinder (B) and install sandpaper pad (C), tighten securely.
l
Place desired sandpaper onto sandpaper pad. NOTE: Use approved self-
adhesive type sandpaper.
IMPORTANT: The tool MUST be in the unlocked position for orbital action.
l
Rotate drive cylinder lock (A) into unlock position.
D22738
All manuals and user guides at all-guides.com
ASSEMBLY
OPERATION
A
B
6- ENG
Sandpaper
Pad
C
B
Trigger
Air Inlet
A