Ex-Cell ETS1 Manual De Instrucciones página 7

l
Set speed between "HI" and "LO" to the desired
variable speed.
l
Connect tool to air hose of recommended size.
NOTE: The use of a quick connect set makes
connecting easier.
IMPORTANT: The use of air filters and air line
lubricators is recommended.
To use:
l
Turn air compressor on and allow air tank to fill.
l
Set the air compressor's regulator to 90 PSI. This tool operates at a
maximum 90 PSI pressure.
l
Depress trigger to operate tool.
l
Release trigger to stop tool.
l
Always disconnect air supply when changing sandpaper pads.
l
When job is complete, turn the air compressor off and store as described
in the air compressor operator manual.
Tips
l
Begin sanding with an abrasive grit sandpaper course enough to remove
the high spots. Progress to a finer grit sandpaper until the desired finish is
obtained.
l
Never change from course grit sandpaper to a very fine grit sandpaper,
always progress to the finer grit.
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and
bearing uses compressed air to power the tool. Because moisture in
compressed air will rust the air motor, you must lubricate the motor daily. An
inline oiler is recommended.
To lubricate the air motor manually:
l
Disconnect the tool from the air supply holding it so the air
inlet faces up.
l
Depress the trigger and place one to two drops of air tool
oil in the air inlet Depressing the trigger helps circulate oil
in the motor. NOTE: Use SAE #10 weight oil if air tool oil is
not available.
l
Connect the tool to an air source, cover the exhaust end
with a towel and run for a few seconds.
exhaust port away from people or objects.
All manuals and user guides at all-guides.com
MAINTENANCE
Any excess oil in the motor is immediately
expelled from the exhaust port. Always direct
Failure to lubricate the tool at the air inlet will
void your warranty.
7- ENG
D22738