Publicidad
Idiomas disponibles
Idiomas disponibles
English
○ When the power cord is not plugged into an outlet and
the battery runs out of power, power output will stop
and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out, change
the battery or plug the power cord into an electrical
outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 11)
○ Remove the battery from the charger and place the
rubber cover over the USB port.
APPLICATIONS
Air compressors are utilized in a variety of air system
applications.
Match hoses, connectors, air tools, and accessories to the
capabilities of the air compressor.
You may use this compressor for purposes listed below:
○ Operating air powered tools requiring less than
1.6 SCFM @ 90 PSI.
○ Powering pneumatic nail guns, infl ating tires,
cleaning / blowing with pressurized air.
WARNING
Do not allow familiarity with compressor and
tools to make you careless. Remember that a
careless fraction of a second is suffi cient to
infl ict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating compressor.
Failure to do so could result in objects being
thrown into your eyes resulting in possible
serious injury.
CAUTION
Do not use in an environment that is dusty
or otherwise contaminated. Using the air
compressor in this type of environment may
cause damage to the unit.
CHECKING THE SAFETY VALVE
Before starting compressor, pull the ring on the safety
valve to make sure that the safety valve operates smoothly.
(Fig. 12) Do not use compressor if the safety valve is stuck
or does not operate smoothly. Have defective safety valve
replaced by a metabo HPT authorized service center.
18
WARNING
Drain tank to release air pressure before pull the
ring on the safety valve.
WARNING
Risk of bursting.
If the safety valve does not work properly, over-
pressurization may occur, causing tank rupture
or an explosion.
Safety valve
USING THE AIR COMPRESSOR
○ Temperature
Operating temperatures are between 32°F and 104°F
(0°C and 40°C).
CAUTION
Never operate in temperatures below 32°F (0°C)
or above 104°F (40°C).
WARNING
Always ensure the power switch is in the OFF (O)
position and the regulator pressure gauge reads
zero before changing air tools or disconnecting
the hose from the air outlet. Failure to do so
could result in possible serious personal injury.
○ Ensure the drain valve is closed (Fig. 13).
○ Ensure the power switch is in the OFF (O) position and
the battery is removed.
○ Ensure the pressure regulator knob is turned fully
counterclockwise (Fig. 13).
Fig. 12
Pull
Publicidad
