Intended Use; Preparation; Assembly - Wentronic Goobay 59509 Instrucciones De Uso

User Manual
3

Intended Use

This product is intended exclusively for private use and its intended purpose. This product is not intended for commercial
use. We do not permit using the device in other ways like described in chapter „Description and Function" or in the „Safety
Instructions". Use the product only in dry interior rooms. Not attending to these regulations and safety instructions might
EN
cause fatal accidents, injuries, and damages to persons and property.
IPX0: This product is not protected against water.
4

Preparation

1. Check the scope of delivery for completeness and integrity.
2. Compare the specifications of product and power supply.
These must be identical.
5

Assembly

13
1. Insert the stand (5) into the base (1).
2. Place the stand and the base on their sides so that you can see the underside of the base.
CAUTION! The base is heavy!
• Make sure that no fingers or limbs are wedged under the base!
3. Place the washer (7) over the hole in the centre of the base.
4. Insert the base screw (6) with the threaded side in the washer.
5. Tighten the base screw clockwise.
The stand and the base are now firmly connected to each other.
6. Put the stand and the base back in place.
7. Slide the rear blade guard (2) on the axle of the motor block (5).
Make sure that the hole at the edge of the rear blade guard is at the bottom.
8. Slide the fixing nut (8) onto the axle of the motor block.
9. Tighten the fixing nut clockwise.
The rear blade guard is now fixed.
10. Push the rotor (4) onto the axle of the motor block.
Make sure that the recesses on the back of the rotor are over the pins on the motor axle.
11. Slide the fixing screw (9) onto the axle of the motor block.
12. Tighten the fixing screw anticlockwise.
The rotor is now fixed.
13. Hang the front blade guard (3) onto the rear blade guard with the hook.
Make sure that the hole on the edge of the front blade guard faces the hole on the edge of the
rear blade guard.
14. Slide the 4 locking clips, each located on the side of the front blade guard, over the frames of
both blade guards.
15. Push the Phillips screw (10) through the holes of both blade guards.
16. Fix the Phillips screw with the screw nut (11).
17. Tighten the Phillips screw clockwise.
The front blade guard is now fixed and the fan is ready for use.