Danby Silhouette Professional DIM32D1BSSPR Instrucciones De Uso página 10

DOOR REVERSAL INSTRUCTIONS
This appliance can be modifi ed for the door to open from either the left or the right side. The unit is delivered to you
with the door opening from the left side. If you wish to reverse the opening direction, follow the instructions below:
F1
1 2
F3
F5
10
1. Remove 2 screws (2) from axis plate (3) at bottom of door. Slide the door from bottom hinge, then pulling down off
of top pin (Fig. F1/F2.) Pull axis plate (3) out from door, and place both door and axis plate aside.
2. Remove 3 screws (7) from the top right hinge, remove hinge (6) and put aside (Fig. F3).
3. Remove decorative plugs (9) from the top left side of the cavity frame (Fig. F4). Replace the decorative plugs into
the top right side of the cavity frame.
4. Line up top left hinge (8) with holes and fasten with 3 screws that were removed from the right side.
5. Place (push in, do not screw in) axis plate (3) into the bottom of the door on left side.
6. Push door onto top hinge pin and slide door onto lower hinge, make sure axis plate is between door and low
hinge.
7. Install 2 screws (2) in the axis plate through the lower left hinge and into the axis plate, making sure the door is
properly aligned to the cabinet.
INSTALLATION INSTRUCTIONS
4
3
6
7
F2
5
F4
8
Fig.F
8
1. Bottom hinge (right)
2. Screws
3. Axis plate
4. Door
5. Hinge pin (right)
6. Top hinge (right)
7. Screws
8. Top hinge (left)
9. Decorative plugs
10. Bottom hinge (left)
9