Panasonic EY6950 Manual De Instrucciones página 7

Taladro de martillo e impulsor inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
NOTE:
Use under extremely hot or cold
conditions will reduce operating
capacity per charge.
Charging
NOTE:
When you charge the battery pack
for the first time, or after prolonged
storage, charge it for about 24
hours to bring the batteries up to
full capacity.
Battery charger (EY0110)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
2. Insert the battery pack firmly into
the charger.
Battry pack
3. During charging, the charging lamp
will be lit.
When charging is completed, an in-
ternal electronic switch will automati-
cally be triggered to prevent over-
charging.
Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be lit
until the battery cools down. Charging
will then begin automatically.
4. When charging is completed, the
charging lamp will start flashing quickly
in green color.
5. When in any of the conditions that
battery pack is too cool, or the bat-
tery pack has not been used for a
long time, the charging lamp is lit. In
6. If the charging lamp does not light
NOTE:
To AC
outlet
CAUTION:
Battery
charger
- 7 -
this case charging takes longer to
fully charge the battery pack, than
the standard charging time.
If a fully charged battery pack is
inserted into the charger again, the
charging lamp light up. After several
minutes, the charging lamp may
flash quickly to indicate the charging
is completed.
immediately after the charger is
plugged in, or if after the standard
charging time the lamp does not go
off, consult an authorized dealer.
When charging a cool battery pack
(below 5°C (41°F)) in a warm place,
leave the battery pack at the place
and wait for more than one hour to
warm up the battery to the level of
the ambient temperature.Otherwise
battery pack may not be fully
charged.
Cool down the charger when charg-
ing more than two battery packs
consecutively.
Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
Do not use power source from an
engine generator.
Do not cover vent holes on the
charger and the battery pack.

Publicidad

Tabla de contenido
loading

Tabla de contenido