Description Of The User Interface - Ferroli EGEA 90 LT Manual De Uso, Instalación Y Mantenimiento

TROUBLESHOOTING / REPLACEMENT / MAINTENANCE
EXPERT TECHNICIAN
/ MANUFACTURER'S
USER
Before carrying out any type of intervention on the device, the
personnel in charge of maintenance must refer to what is re-
ported in this manual in the following chapters and in particular
to consult chapter "8. REQUIREMENTS FOR THE OPERA-
TION, SERVICE AND INSTALLATION OF APPLIANCES THAT
USE FLAMMABLE REFRIGERANT GASES ACCORDING TO
ANNEX DD OF EN 60335-2-40" on page 149.
FERROLI S.p.A. cannot be held
responsible
carried out by non-expert and
ATTENTION
non-qualified personnel.
DO NOT TAMPER WITH THE
POWER CORD.
If the power supply cable is dam-
ATTENTION
aged, it must be replaced by the
manufacturer or the technical as-
sistance service or in any case
by a person with similar qualifi-
cations, in order to prevent any
risk.
116
EN
Periodicity:
IN CASE OF
ANOMALY OR
FAULTS.
TECHNICAL
ASSISTANCE
for interventions
cod. 3541T580 - Rev. 06 - 04/2022
2.4

DESCRIPTION OF THE USER INTERFACE

Description
"On/Off" button for switching on, putting the product in
standby mode, unlocking buttons, saving changes
"Set" button to edit the parameter value, confirm;
"Increase" key to increase the set-point value, parame-
ter or password
"Decrease" key to decrease the set-point value, param-
eter or password
Heat pump operation (ECO mode)
Heating element operation (electric mode)
Automatic mode
Boost mode (symbols flash)
Button lock active
Defrosting
Frost protection
Anti-legionella cycle
Holiday mode;
Operation with time bands
Clock setting (symbol flashes)
Connected with Wi-Fi
(the symbol flashes when there is no connection)
Photovoltaic mode
(with symbol flashing the supplement is not active)
NOT USABLE
Fault or protection active
Off-Peak mode (with symbol flashing the equipment re-
mains on standby)
EGEA
90 LT - 120 LT
fig. 1
Symbol
+
+