KNOVA KN M-3059R Manual Del Usuario página 23

OPERATION
Fig. QQ
F
e
n
c
Workpiece
e
Miter Saw Table
Bevel/Miter Settings
NOTE: The chart below references a compound cut for crown molding
ONLY WHEN THE ANGLE BETWEEN THE WALLS EQUALS EXACTLY 90°.
BEVEL ANGLE
KEY
SETTING
IL 33.9º
IR 33.9º
OL 33.9º
OR 33.9º
Settings for standard crown mold-
ing lying flat on compound miter saw
table.
MITER ANGLE
SETTING
31.6° Right
31.6° Left
31.6° Left
31.6° Right
22
Inside
Corner
IL
Compound cut crown moldings
T Y P E O F C U T
Inside corner-Left side
1. Position top of molding against fence.
2. LEFT side is finished piece.
Inside corner-Right side
1. Position bottom of molding against fence.
2. LEFT side is finished piece.
Outside corner-Left side
1. Position bottom of molding against fence.
2. RIGHT side is finished piece.
Outside corner-Right side
1. Position top of molding against fence.
2. RIGHT side is finished piece.
Fig. RR
OR
OL
IR
Outside
Corner