Usage Of The Charger; Battery; Maintenance; Transport - URBANGLIDE BIKE 160 Traducción De Las Instrucciones Originales

•

Usage of the charger

A plastic cap is located on the loading port of your scooter, remove it to load your product, and do not forget
to put it back before using your scooter so as not to damage the loading port. Before using the product, it is
necessary to charge it. A long charge may be necessary before the first use. Please refer to the battery
indicator, you can charge your battery at any time to ensure the constant power. It is not necessary to wait
until the battery is completely empty to charge it. Please do not use the charger of other brand, these can
damage the battery of your product. To ensure a normal life cycle, it is important to charge your battery at
least once every 3 months, even if you are not using the product. It is imperative to use the supplied charger
which is specially designed for this scooter.
Avoid shocks and contact with water, these are factors not covered by the warranty that may damage the
battery. The supplied charger is "smart", it will stop at 100% of the charge and not damage the battery. The
charger must be in perfect condition during each use, verify the wires, the condition of connection ends and
connectors. If the product does not charge, the charger may be defective, it needs to be replaced.
The charger must be used only by an adult, it is important to unplug it from both sides when not charging.
•

Battery

Please do not store the battery in extreme temperatures. Store it below 30 ° C and above 0 ° C. If you do
not use your product for 60-90 days, the battery may get worse. This loss of autonomy is due to lack of use
and is therefore not covered by the warranty.
At the end of its cycle, the battery must be discarded separately from the undifferentiated generic waste.
Discard the batteries in the containers provided for this purpose. The recovery and recycling of batteries
contributes to protect the environment and material resources conservation.
•

Maintenance

Please store your product in a dry, dust-free place, and avoid leaving it in a humid area or under the sun for
too long. To clean your appliance, use a damp cloth and mild detergent. Do not use alcohol, gasoline,
kerosene, or other corrosive chemical solvents to clean your appliance, which will damage its appearance
and structure.
Constantly verify the condition of components of your product, if any part is damaged, please replace it
before using the product. If a part is not working, falling and injuring may occur. Do not disassemble the
scooter in case of breakdown, otherwise the warranty will cancel. Before any intervention, it is advisable to
turn off your scooter. For all spare parts, please contact your dealer
•

Transport

If you wish to transport your product by air or other means of transport as well as its battery, please contact
the local authorities and the carrier beforehand to obtain the possible prohibitions and limits of transport.
Lithium batteries are considered dangerous in many countries. Please make sure that the access and
transport are allowed before travelling. International law prohibits the transport of lithium batteries by air.
•

Using the scooter

To turn on your product, press the Power button, then press the accelerator to advance. To move forward,
place both feet on the board, and use the right trigger on your handlebars to advance your scooter. To brake,
you can use the left trigger on your handlebar, or press the rear fender with your foot to reduce the speed of
your scooter. Before each use, please check that the wheels are not clogged, that the brakes are working
and that no warning message is displayed. Using the scooter for long periods can cause vibrations that can
be unpleasant, make poses regularly. When stopped, use the stand to stabilize your product. Unfold it with
your foot. To warn other users of your presence, use the horn located on the handlebars.

Rebus

THIS TROTTINETTE CONTAINS LITHIUM BATTERIES THAT MUST BE RECYCLED SAFELY. Recycling:
The battery must be removed before being discarded. Before any work, remember to turn it off and unplug it
from the power outlet.
2