Thermostat Setting - EAS ELECTRIC EMR1092DS2 Manual De Instrucciones

Frigorífico expositor de botellas con puertas correderas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not allow the cables of your product connected to the
mains to contact hot surfaces. Outlet that shall be used
shall always be grounded. It the outlet that shall be used
shall also be protected with a proper fuse with a rating of
10-16 A minimum. Always get support from our authorized
service or a qualified electrician for the fuse that shall be
installed on the electrical installation where the outlet is
connected. (Figure 6)
The voltage and frequency of mains power should be the
same as the values specified on the label on the inner
surface of your appliance. If mains power is far below or
above the specified value, have the desired voltage by
using a voltage regulator. You can get help from a qualified
electrician.
Do not put the cable of your product on passage routes.
These may cause injury to you and damage to your cooler.

THERMOSTAT SETTING

Temperature settings of your cooler is performed in our
factory for operation in suitable conditions.
Temperature for the preservation of the food is adjusted
with the thermostat by observing it from the thermometer
on your cooler (optional).
Picture 6
16

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido