Important - Zonair3D Air+ 300 S Manual De Usuario

Opening instructions and filter removal

Important:

· Before removing any panel, check that the unit is not switched to the electric power
network.
· It is recommended to use gloves when replacing the filters to avoid any contact with
adsorbed substances.
· Always take the filters by the frame. Never touch the filter surface.
1
Slide the rear exterior panel
of the unit along its track,
about 5 cm vertically, and then
outwards
2
To access inside, unscrew the
6 screws on the interior metal
panel with a Phillips
screwdriver.
3
Identify filter.
Absolute filter
Fan
GRSystem
Pre-filter
4
Remove the pre-filter by sliding
it along the guides.
5
Remove the GRSystem filter by
the handle, lifting it about 2cm
and pulling it outwards (always
sliding the bottom flap of the
filter under the lateral guides).
Handle
Flap
6
Loosen the 4 setscrews hol-
ding the absolute filter in each
corner so that it can be fully
removed along the guides.
Air+ 300 S & 430 S · Page 24