• Children shall not play with the device.
• Cleaning and user maintenance shall not be
made by children without supervision.
• Children aged from 3 to 8 years are allowed to
load and unload cooling devices.
Explosion hazard
• Do not store any explosive substances such as
spray cans with a flammable propellant in the
cooling device.
!
CAUTION! Failure to obey these cau-
tions could result in minor or moder-
ate injury.
Electrocution hazard
• Before starting the cooling device, ensure that
the power supply line and the plug are dry.
• Disconnect the cooling device from the power
supply
– before each cleaning and maintenance
– after every use
Health hazard
To avoid contamination of food, please respect the
following instructions:
• Please check if the cooling capacity of the device
is suitable for storing the food or medicine you
wish to cool.
• Food may only be stored in its original packag-
ing or in suitable containers.
• Opening the cooling device for long periods
can cause significant increase of the temperature
in the compartments of the device.
• Clean regularly surfaces that can come in contact
with food and accessible drainage systems.
• If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the lid open to prevent mold develop-
ing within the device.
A
NOTICE!
Damage hazard
• Check that the voltage specification on the data
plate corresponds to that of the energy supply.
• Only connect the cooling device as follows:
– With the DC connection cable to a DC power
supply in the vehicle
– Or with the AC connection cable to an AC
power supply
• Never pull the plug out of the socket by the
cable.
12
• If the cooling device is connected to a DC outlet,
disconnect the cooling device and other power
consuming devices from the battery before con-
necting a quick charging device.
• If the cooling device is connected to a DC outlet,
disconnect the cooling device or switch it off
when you turn off the engine. Otherwise you
may discharge the battery.
• The cooling device is not suitable for transport-
ing caustic materials or materials containing sol-
vents.
• The insulation of the cooling device contains
flammable cyclopentane and requires special
disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate
recycling center.
• Do not use electrical devices inside the cooling
device unless they are recommended by the
manufacturer for the purpose.
• Do not place the cooling device near naked
flames or other heat sources (heaters, direct sun-
light, gas ovens etc.).
• Risk of overheating!
Ensure at all times that there is a minimum of
50 mm ventilation on all four sides of the cooling
device. Keep the ventilation area free of any
objects that could restrict the air flow to the cool-
ing components.
Do not place the cooling device in closed com-
partments or areas with none or minimal air flow.
• Ensure that the ventilation openings are not cov-
ered.
• Do not fill the inner container with ice or fluids.
• Never immerse the cooling device in water.
• Protect the cooling device and cables against
heat and moisture.
• The device shall not to be exposed to rain.
Intended use
The device is suitable for:
• Operation in vehicles
• Cooling and deep-freezing food
• Camping use
The device is not suitable for:
• Storage of corrosive, caustic or solvent-contain-
ing substances
• Quick-freezing of food
4445102905