ECRON AD 836A Manual De Usuario página 38

ALIGNMENT OF THE
BLADES
· Your cutter was carefully
examined to ensure that the blades
were aligned and lubricated before
leaving the factory.
· The blades must be realigned
if they have been cleaned
or replacement.
· To align the blades, simply pair
up the tips of the upper and lower
blades. The tips of the teeth on
the upper blade should be
approximately 1.2 mm from the
lower blade (compare the blades
of your cutter with the diagram).
· If the blades are not aligned
correctly, put a few drops of oil on
the blades, turn the cutter on for a
few moments, turn off and
disconnect. Loosen the screws
38
1,2mm
lightly and adjust. Tighten screws
once the blades are aligned.
LUBRICATION
· To keep the blades of your cutter
in optimal conditions, the blades
must be lubricated before every use.
· Do not use hair oil, grease or oil
mixed with kerosene or solvent, as
the solvent will evaporate and
thicken the oil, thus slowing down
the movement of the blades.