Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
π
H-5746, H-5747
CASTERS FOR STAINLESS
STEEL WORKTABLE
PAGE 1 OF 3
1-800-295-5510
uline.com
ASSEMBLY
Figure 1
Nylon Bushing
Rubber
Expansion Piece
Caster Base
Figure 2
Figure 3
Tube Leg
1.
Flip the table over onto a smooth, non-marring
surface. Remove adjustable feet from tube legs
using a flat head screwdriver. (See Figure 1)
NOTE: You may need to use a rubber mallet or
hammer to assist.
2. Hold caster base and rotate nylon bushing
clockwise. This will cause the rubber piece to
expand. (See Figure 2)
3. Expand the rubber enough so that it will fit snugly
into the tube leg.
4. With caster fully inserted into the leg, turn clockwise
until caster is secured to tube leg. (See Figure 3)
NOTE: If too loose, pull out caster and tighten
further. Repeat step 2.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
0421 IH-5746
Publicidad
Manuales relacionados para Uline H-5746
Resumen de contenidos para Uline H-5746
- Página 1 Para Español, vea páginas 4-6. Pour le français, consulter les pages 7-9. π H-5746, H-5747 1-800-295-5510 uline.com CASTERS FOR STAINLESS STEEL WORKTABLE ASSEMBLY Flip the table over onto a smooth, non-marring Figure 1 surface. Remove adjustable feet from tube legs using a flat head screwdriver.
- Página 2 π H-5746, H-5747 800-295-5510 uline.mx RUEDAS PARA MESA DE TRABAJO DE ACERO INOXIDABLE ENSAMBLE 1. Voltee la mesa hacia arriba sobre una superficie Diagrama 1 lisa que no la raye. Quite los tapones ajustables de las patas tubulares utilizando un desarmador plano.
- Página 3 π H-5746, H-5747 1-800-295-5510 uline.ca ROULETTES POUR TABLE DE TRAVAIL EN ACIER INOXYDABLE MONTAGE Retournez la table sur une surface lisse non Figure 1 marquante. Retirez les pattes réglables des pieds tubulaires à l'aide d'un tournevis à tête plate. (Voir Figure 1) REMARQUE : Utilisez un maillet en caoutchouc ou un marteau au besoin.