Safety Devices - Elettro CF 486 Manual De Instrucciones

Before using this device, all people authorized to its use, repair or inspection, should read the book "Safety rules for using machines"
and the "Instruction manual" specific for every machine. Contact your distributor if you have not understood some instructions.

1 SAFETY DEVICES

This unit is provided with the following safety devices :
Thermic : located on the power transformer windings to avoid overloads and signalled by indicator light G on (see picture 1).
Pneumatic : located on the torch feed line to avoid insufficient air pressure and signalled by indicator light H (see picture 1).
Electric :
1) located on torch body to avoid dangerous voltages while replacing nozzle, diffuser, electrode or nozzle holder.
2) to stop the machine when there is high input voltage tension, this function is signalled by indicator light F (picture 1)
• Do not remove or short-circuit the unit safety devices.
• Only use original spares.
• Always replace any damaged part of the unit or torch with original material.
• Do not use any torches other than the original one.
• Do not let the unit work without covers. This would be dangerous for operator and for those who are surrounding the work
area and would prevent the unit from cooling efficiently.
2 DESCRIPTION OF TECHNICAL SPECIFICATIONS
IEC 974-1 This machine is manufactured
EN60947-1 according to these international standards.
ART Article number with serial number must
3 DESCRIPTION OF UNIT DEVICES (see pictures 1 and 2)
A) Torch cable pressing device.
B) Texas connection.
C) Cutting power adjusting knob.
D) Torch.
E) Mains pilot light.
F) Light signalling danger over-tension.
G) Light signalling thermostat.
3.1 ASSEMBLY AND ARRANGEMENT
Unpack the unit and assemble the handle with the supplied spanner. Place the unit in properly ventilated if possible undusty room,
making sure that the air inlet and outlet from cooling slots are not obstructed.
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR PLASMA CUTTER
appear on any requests concerning the
machine.
Single-phase
transformer-rectifier.
Drooping characteristic.
Plasma arc cutting.
Uo Secondary no-load voltage.
X Duty-factor
expresses the percentage of 10 minutes in
which the welding machine can operate at a
determined current, without over-heating.
I Welding current.
2
U Secondary voltage with welding current I
2
U Nominal supply voltage.
1
1~50/60Hz Single-phase supply 50 or 60Hz.
I Absorbed current at the corresponding welding
1
current I .
2
IP23 Grade of protection of frame. Grade 3 as a
second number means that this unit is fit to
work outside.
Fit to work in high - risk areas.
NOTES : In addition, the welding machine has been designed
to work in areas with grade 3 of pollution (See IEC 664).
H) Light signalling air pressure is not enough.
L) Cable pressing device.
M Fan grid.
N) Mains switch.
O) Gauge.
P) Air pressure reducing unit.
Q) Feed cable.
static frequency converter-
percentage. The duty-factor
.
2
6