Descargar Imprimir esta página

SJE Rhombus Xpert Alert RF Instrucciones De Instalación página 2

Publicidad

Panel Installation
a
Install the panel module securely in a 4X rated enclosure.
min.
3 ft.
®
Remove Xpert Alert
alarm cover. Insert alarm module into the USB
port. Mount alarm (indoor only) using keyhole on the back of the unit.
DO NOT INSTALL PANEL MODULE IN TANK.
Replace cover and connect
USB power cable.
Refer to Xpert Alert
instructions for fl oat switch
installation, battery back up,
and operation.
4X Installation
b
Securely mount 4X enclosure.
Refer to schematic for wiring panel module.
min.
3 ft.
Test alarm weekly to insure
proper operation.
®
alarm
Max
1 2 3 4 5 6
200ft.
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30 31
BLACK
WHITE
ORANGE
WHITE/RED
Dry Contact
L
N
120VAC
Warning: only connect to dry contact closure.
Refer to operation
guide for start up.
Xpert Alert
®
RF Alarm
Operation Guide
Alarm LED
Pairing Button
Signal Strength
Step 1: Installation
Mount and wire the alarm according to the installation instructions.
***Maximum distance between modules should be 200ft.
Step 2: Signal Strength Check
Press pairing but-
ton for 1 second on the panel module to enter setup mode for fast signal
strength updates.
Reposition the indoor module until 1 or more signal LEDs are illuminated green.
Step 3: Test Alarm
Verify the alarm is functioning by triggering an alarm condition on the outdoor panel and verify the
indoor Xpert Alert® alarm is alarming. Alarm LED on Xpert Alert® RF
will illuminate amber in color when alarming and the audible alarm will sound. For Xpert Alert® WiFi
cation of alarm was received.
Monthly Testing
Verify at least 1 or more signal LEDs are illuminated green monthly
are able.
and Xpert Alert® alarms
, and repeat step 3 as you

Publicidad

loading