Changing The Position Of The Seat; Placing The Child In The Seat - JANE IKONIC R Manual De Instrucciones

Extract the ISOfix anchors (6) by turning the handle (9) on the side of
the base. The anti-rotation leg (12) will unfold due to IKONIC R.
Guide both anchors towards the connectors and press until both sides
are locked, two green signals on the base (8) will show that both sides
are correctly anchored. If one or both of the signals are red, repeat
this step. .b
1
Turn the handle (9) anti-clockwise to fit the safety seat firmly against
the backrest of the vehicle seat.
Pull the leg lock (12b) and extend it until it makes contact with the
floor of the vehicle. The signals on the foot of the leg (12a) will turn
green. .d
1
Release the leg lock and extend the leg manually until it locks again.
The lock signal will turn green.
F_CHANGING THE POSITION OF
THE SEAT
The IKONIC R safety seat can be used in the rear facing position from
birth up to when the child is 105 cm tall or in the forward facing posi-
tion from 15 months up to when the child is 105 cm tall.
The seat can be turned round 360°, the rotation only locks in the two
positions of use: rear facing and forward facing.
To change the position of the seat:
Pull the lever (13) found on the side of the sear and pull the seat
towards you. .a
2
22
EN
.c
1
.e
1
Release the lever and turn the seat to the required position. It will lock
.a when it reaches the position for travelling.
1
WARNING: In vehicles that are not fitted with rear seat doors,
!
the rotation of the seat is limited due to the space between
the seat and the sides.
G_PLACING THE CHILD IN THE SEAT
The IKONIC R safety seat should preferably be installed on the rear
seat of the vehicle. Before installing the safety seat, make sure that the
vehicle seat where you are going to install it is i-Size, or that it is fitted
with ISOfix anchors and that your vehicle is on the list of compatible
vehicles.
To make it easier to place the child in the seat, you can turn the seat
so it faces the car door. The seat will not lock in this position, once
the child is in the seat the seat should be turned back to the position
for travelling.
For babies up to 60 cm in height use the cushion insert.
When using the insert, the headrest of the seat should be in the lowest
position. Read section H for instructions on how to adjust the headrest
height.
Place the cushion insert in the seat, passing the shoulder straps
through the slot below the headrest.
Fasten the baby in following the steps below:
•Pull the lever (13) found on the side of the seat and turn the seat.
.a
3
.b
2