Removing The Seat From The Vehicle; Recommendations; Maintenance - JANE IKONIC R Manual De Instrucciones

J_REMOVING THE SEAT FROM THE
VEHICLE
Loosen the tension of the ISOfix anchors by turning the handle (9).
.a
6
Release the ISOfix anchors by pressing both unlocking buttons (7).
The signals on the side (8) will turn red.
Remove the safety seat. You can store the ISOfix anchors inside the
base by turning the handle (9) and fold the leg.
K_RECOMMENDATIONS
Keep this instruction book for future reference. Always keep it in the
pocket behind the backrest (11).
Inside the vehicle make sure that all luggage and any other objects that
could cause damage in the event of an accident are properly secured
or stored.
The IKONIC R safety seat must be properly fastened to your vehicle
with the Isofix anchors, even when it is not in use, because in the
event of an accident it could get flung about and could injure the other
occupants of the car.
24
EN
.b
6
L_MAINTENANCE
Do not expose the upholstery to sunlight for long periods, when the
seat is not in use, cover it or store it in the boot.
Wash the plastic parts with soap and warm water, carefully drying
all the components afterwards. The upholstery can be removed for
washing. Follow the instructions below:
Headrest:
Remove the upholstery from around the headrest and underneath the
overhang of the headrest.
7
Shoulder and crotch strap pads:
Undo the Velcro strips on the shoulder pads and take them off the
straps. .b
7
Upholstery on the seat part:
Unfasten the two side parts and take the cover off all around the edges
of the seat. .c
7
Wash at a temperature never higher than 30ºC.
To fit the upholstery back on, follow the same steps in reverse.
.a