Publicidad
Idiomas disponibles
Idiomas disponibles
Connections & Indicators
LEDs
The LED indicators make it easier to
monitor the switch and its connections.
Ports
All RJ45 ports on the switch support Auto-
MDI/MDI-X functionality, so crossover cables
and uplink ports are not needed for connections to PCs, routers, other switches,
etc. Cat5/5e/6 UTP/STP cables provide optimal performance; if a status LED doesn't
indicate a link, check the corresponding device for proper setup and operation.
Power
Use the included power cord to connect the device to an AC outlet.
Confirm that the power LED on the front panel is lit.
Placement
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch
• with a minimum of 25 mm (approx. 1") of clearance on
the top and sides for adequate ventilation
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.
• where it cannot be affected by excessive moisture
Chassis Ground Column (Rear Panel)
Wire the grounding terminal to an earth grounding object to
protect equipment from external electrical surges.
Rackmount
The switch includes brackets and screws
for optional rack mounting.
1 Disconnect any cables from the switch.
2 Position a bracket over the mounting holes on one
side of the switch and secure it in place with screws.
3 Repeat Step 2 on the other side of the switch.
4 Position the switch in the rack and
screw the brackets to the rack.
5 Reconnect any cables.
For specifications, visit intellinetnetwork.com. Register your product at register.
intellinet-network.com/r/561877 or scan the QR code on the cover.
2
English
LED
Color
Status
Off
Green
PWR
On
Off
LINK/
Green
On
ACT, SFP1,
Flashing Sending or receiving data.
SFP2
2
4
Instructions
Status Description
Power Off
Power On
No link established.
Valid port connection.
&
3
Publicidad
