Usage - Beurer SatinSkin HL 76 Instrucciones De Uso

5. USAGE

Commissioning/charging the battery
The device should only be charged with a mains adapter with an output of min. 1 A.
1. Charge the device for approx. 2 hours before initial use. You can either charge the device directly
(Figure ) or connect it to the charging station (Figure
A
vice to a suitable mains adapter (mains adapter not included in delivery scope) or via a device with a
suitable interface.
2. The battery level indicator
level indicator stays on continuously. The device is now ready for use. One charge is sufficient for
3
approx. 40 minutes of operation.
Epilating
1. Press the ON/OFF button
2. To increase the speed setting, press the ON/OFF button
3. Cleanse skin before epilation to avoid redness. Ideally, epilate after or during the shower to make it
easier to pull out your hair. The device can be used both on dry skin and in the shower or in the bathtub.
4. Place the device vertically on your skin. Guide the device slowly, steadily and without pressure over
the skin against the direction of hair growth (Figure
guide the device over the skin in various directions. For best results, use your free hand to tighten the
skin to make the hair stand up. For thorough epilation, the hair should be about 2 to 5 millimetres long.
Be aware that the underarm and bikini areas may be particularly sensitive to pain at first. We
therefore recommend that you use the lowest speed setting upon initial use. The pain will
lessen with repeated use. As skin in this area is particularly sensitive after epilation, do not use
any substances that might irritate the skin such as alcohol-based deodorant.
5. To switch off the device, press the ON/OFF button
during battery operation, the battery is almost empty.
6. You can also attach the following two attachments to the epilator attachment
Glide attachment
To do this, attach the glide attachment
Precision attachment
To do this, attach the precision attachment
Shaving/trimming
1. You can also use the device for shaving or trimming:
Shaver attachment
Trimming attachment
flashes during charging. Once the battery is fully charged, the battery
3
to switch on the device.
2
: For gentle gliding over skin during epilation.
7
: For epilation of very sensitive areas.
8
: For a gentle shave of the skin.
10
: For shortening hair to 4 mm. To do this, place the trimming attachment
11
onto the shaver attachment
). Connect the charging station or the de-
B
again.
2
). As hair doesn't always grow in one direction,
C
again. If the battery level indicator
2
to the epilator attachment
7
to the glide attachment
8
(Figure
10
15
:
6
(Figure ).
6 E
(Figure ).
7 F
).
H
3
flashes red
11