Care And Cleaning - AVS Aeroskin LightShield Pro Instrucciones De Instalación

Installation Steps
Consult vehicle owners manual to access headlight / turnsignal plugs. Unplug headlight /turnsignal wiring harness. Use testlight to
identfy and confirm correct wires.
NOTE: To identify parking lights, make sure to turn on parking lights ONLY.
To identify turn signals, engage hazards/emergency flashers.
Once wires are identified, note the following:
23
NOTE: Connect the black wire to vehicle plug ground wire. Connect brown wire to vehicle marker/parking light wire.
Connect yellow wire to left (driver side) turn signal wire. Connect green wire to right (passenger side) turn signal wire.
To connect wires: (1) Slide slotted cap over vehicle wire, (2) Screw main connector body into slotted cap (pin side screws
into slotted cap), (3) Strip approximately 1/4" from each LightShield wire, (4) Insert electrical wire into open cap. Tighten
onto opposite end of main connector body, confirm connection by gently tugging on LightShield wire.
Vehicle Wire
1
24

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade™, the Auto Ventshade™ logo and the AVS™ logo are trademarks of Lund, Inc.
™
NOTE: Actual application may vary slightly from illustrations.
Black wire = ground
Brown wire = parking light
Yellow wire = left turn signal (driver side)
Green wire= right turn signal (passenger side)
Repeat steps for remaining wires.
Tighten Main Connector Body
2
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2021 Lund, Inc. All rights reserved.
LightShield wire
3
The material that your product is made from can
be recycled. Please also consider recycling the
Page 7 of 7
Insert and Tighten
4
packaging that your product came in.