Before Installation; Installation Procedure - Toto CST243 Manual De Instrucciones

Read these instructions thoroughly before beginning work.
Please leave instructions for customers. These instruction contain maintenance
and warranty information.
If necessary, remove the existing toilet and if new construction,
purge the supply line.
IMPORTANT!
Due to the powerful performance of our Cyclone, G-Max, E-Max and Power Gravity
flushing systems, they are not specified for back-to-back installations. The only
means of installing these toilets in a back-to-back situation is when the toilet drain
connections incorporate a WYE fitting. Please contact your builder or contractor prior
to this installation.
For your new TOTO toilet to fit correctly, the
rough-in, the distance between the finished wall to
the center of the closet flange, must be at least 12
inches for most models.
NOTE: Models with 10" or 14" rough-in have
model numbers ending with ".10" or ".14", for
example C744EF.10 or C744EF.14. Straight stop
type valve, or valve with supply connection on
front of angle stop, is not recommended.
1) Clean any debris out of the closet flange and then install new
mounting bolts (not supplied) into the slots of the closet
flange (see Illustration 1). The head of the bolt should be
inserted into the slot with its threads facing upward.
2) Carefully turn the toilet upside down onto some padding.
Firmly press a new bowl wax ring (not supplied) onto the
circular recess around the toilet bowl's horn (see Illustration 2).
3) Turn the toilet upright and gently lower into position over the
both sides of toilet rim to set the bowl wax ring
(see Illustration 3).
CAUTION: Do not move the bowl after the
bowl wax ring is set. Thread the nuts and
tighten evenly until bowl is snug to closet
flange. Install the bolt caps (see Illustration 3).
CAUTION: Do not over-tighten the nuts as
damage to the china bowl may result.

BEFORE INSTALLATION

Double Combination WYE / 1/8 Bend
YES

INSTALLATION PROCEDURE

3
Double Sanitary Tee / Sanitary Cross
Centerline of
Flange
Ill. 3 Three Points of Contact
Bolt Cap
Nut *
Washer *
Base Cap
Bowl Base
* Not Supplied
NO
Centerline of
Stop valve
"RI"
Ill. 1
Ill. 2
Wax Ring
Horn