Bimar HR314 Folleto De Instrucciones página 13

• If the appliance is not being used, unplug it from the power point.
• WARNING: The heater must not be used if the quartz tubes are
damaged.
• WARNING: in order to avoid overheating, burns or fire, do not cover
the appliance.
• Do not use the appliance to dry clothes.
• Do not use the appliance in sauna rooms.
INSTALLATION
• After unpacking, check that all parts of the appliance are intact; if in doubt, do not use and
contact a qualified technician. The packaging materials (plastic bags, expanded polystyrene,
rivets, etc.) must not be left within reach of children, as they are potentially hazardous.
• Before installing the appliance, make sure that:
- the electrical system to which the appliance will be connected complies with current standards
and has cables whose cross-section is suitable for the absorbed power
- the voltage values on the nameplate correspond to those on the power grid, and the socket has
an effective grounding. Check that other appliances with high absorption are not connected to
the power line to avoid overloading and fire hazards. In the event of incompatibility between the
power socket and the appliance's plug, have the plug replaced with a suitable model by a
qualified professional, who should ensure that the cable is appropriate for the power rating of
the device. The use of adaptors or extensions is generally not advisable; if it is necessary to use
them, they must comply with safety regulations and the total current (amps) must not be rated
lower than the maximum current of the appliance.
• Place the heater:
- On a stable and not sloping area (as the unit may fall over).
- far from other heat sources, flammable materials (curtains, tapestries, etc.), flammable gases
or explosive material (spray cans) and materials that may be deformed by heat.
- at a distance of 1 metre from the walls and at least 100 cm from the ceiling: if the stove is
positioned under a patio, check that the roof of the patio is not damaged or burnt by the heat
emitted.
- away from water tanks, swimming pools, etc.
- far from places where it may be subjected to impacts.
•
Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself or twisted.
• To install the appliance, proceed as follows and refer to the figures: the appliance must only
be used in its position