How To Manage: Error Codes; Service Data - AEG BD742P Manual De Instrucciones

TROUBLESHOOTING
Components
Description
The lamp is burnt out.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
C2 - the Food sensor is in the oven cavity dur‐
ing Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolyt‐
ic Cleaning.
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
F908 - the oven system cannot connect with
the control panel.

12.3 Service data

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the oven cavity. Do not remove the rating plate from the oven cavity.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
108/272
Remedy
Replace the lamp, for details refer to "Care and
Cleaning" chapter, How to replace: Lamp.
Remedy
Take out the Food sensor.
Close the door.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
Turn the oven off and on.
.........................................
.........................................