Function With The Ptt Switch - PRESIDENT BILL II Manual Del Usuario

"
- Sensitivity " : allows the adjustment of the microphone
(original one or optional vox) for an optimum transmission quality.
Adjustable level from1 (high level) to 9 (low level).Default value:
2 .
"
- Anti-Vox " : allows disabling the transmission generated
by the surrounding noise. The level is adjustable. OF (according
the squelch level) and from 0 (without anti-vox) to 9 (low level).
Default value: Of .
- Delay time " " : allows avoiding the sudden cut of the trans-
mission by adding a delay at the end of speaking. The level is
adjustable from 1 (short delay) to 9 (long delay). Default value:
1.
ox Adjustment does not automatically active the
The V
VOX function.
See the § VOX on page 46 to
VOX function.
8) EMG
An emergency channel is automatically selected when
by pressing EMG Key (8). First short press to
emergency customisable channel. "
on the display. Second short press to
emergency customisable channel. "
the display. Third short press to
channel. "EMG..." disappears on the display.
See then Table page 74 for default emergency chan-
nels.
Consult the menu EMG SETTING page 48.
7 + 8) KEY LOCK
(long simultaneous press)
Press and hold simultaneously the VOX key (7) and the
EMG key (8) to lock/unlock
activate/deactivate
the
call
the first
" appears
call
the second
" appears on
go back to the current
then unit. " " appears on
the display when the function is activated.
Note: The PTT switch (11) remains enable while the unit is
locked.
9) USB CHARGING SOCKET
The USB socket (9) can be used to
tablet or other rechargeable device with 5 V - 2.1 A.
10) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver
and makes the setting of the equipment into the dash-
board easier. The BILL II accepts electret or dynamic
microphone (see menu MIC TYPE on page 49).
See cabling diagram page 70.
11) PTT (Push To Talk)
Transmission key, press PTT switch to
is displayed and release to
communication.
TOT (Time Out Timer)
If the PTT switch (11) key is pressed for more than 3 minutes,
the display starts blinking and the transmission ends.
A beep will sound until the PTT switch (11) key is released.
C) FUNCTION WITH THE PTT SWITCH
1) VOX
Press and hold then PTT switch (11) and then press the
VOX key (7) to activate/deactivate
"VOX" appears on the display when the function is on.
46
charge a smartphone,
transmit a message,
listen
to an incoming
the VOX function.