• Reposition the solar panel in an optimal position
If the panel is completely under the shade, it can be shifted to another side of the
building. Extension cables of various lengths are available to facilitate this type of
installation. When mounting the device on plaster, use wall-mounted spacers avail-
able for the solar panel (for further details, contact the Nice technical assistance
service) (fig. 5).
5
• Double the solar energy
Nice solar heating systems can function with two solar panels. If the solar perfor-
mance is insufficient, despite all the optimisation measures, a second solar panel
can be installed to increase the solar performances (for further details contact the
Nice technical assistance service) (fig. 6).
6
Connection example
7
Solar Panel
Climate Sensors
ERA W
ERA P
Transmitter
8 – English
Solar Panel
optional (*)
Motor
2.2.3 - Fastening the solar panel
• The device can be fastened in two ways depending on the version:
- on a smooth and clean surface using the two rubber adhesives located on the
back (solar panel cod. 13 125.1901)
- using two suitable screws/blind rivets (cod. 16 307.1001 - optional) and passing
them through the recesses on the panel (solar panel cod. 13 124.7001 - option-
al). Tighten the screws while being careful not to damage the panel.
Avoid leaving loose or hanging cables.
2.3 - Connect and disconnect the battery cables
The steps to be carried out for connecting and disconnecting the connections from
the battery (Fig. 7) are listed below.
For the connection:
• shift the mechanical switch to OFF
• insert the connector coming out of the motor
• insert the connector coming out of the solar panel
• shift the mechanical switch to ON
For the disconnection:
• shift the mechanical switch to OFF
• remove the connector coming out of the motor
• remove the connector coming out of the solar panel
(*) A second additional solar panel (not supplied) can
only be connected using the appropriate Y-shaped ca-
ble available as an accessory.
Y-Cable
optional (*)
Switch
Battery Pack