Install Support Brackets - Toshiba RAC-WK1823ESCWRU Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Install Cabinet
Sill
Fig. 12
FIG.13A
1/2" long
HEX-HEAD
SCREW
A
FIG.13B
B
C

4. Install Support Brackets

Mark
Fig. 14
Page 16
A. Open window and mark center of window sill as shown (Fig. 11).
Fig. 11
B. Place the cabinet in the window with the cabinet bottom fi rmly
seated over the window sill as shown. Bring window down
temporarily behind top rail to hold cabinet in place (Fig. 12).
C. Shift cabinet left or right as needed to line up center of
cabinet on center line marked on sill.
D. For wooden window: Fasten cabinet to window inner sill with
two 1/2" long hex head screws into holes (Fig.13A). (You may
wish to pre-drill pilot holes.)
For Vinyl-Clad window: Place two safety locks into the holes
located in the bottom of the cabinet and drive two #10X1/4"
pan-head Phillips locking screws through the safety locks
into the cabinet as shown (Fig.13B).
A. #10 X 1/4" pan-head Phillips screws
B. Safety Lock (Only for Vinyl-Clad Window)
C. Bottom Rail Foam Seal
E.
Remove protective strip from adhesive side of Bottom Rail
Foam Seal. Apply Seal over screws fastening bottom rail to
window inner sill.
A. Hold each support bracket fl ush against outside of sill, and tight
to bottom of cabinet as shown in Fig. 14. Mark brackets at top
level of sill, and remove.
User Manual

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido