Bergstrom DUAL POWER II Instrucciones De Montaje página 26

DUAL POWER II
EN
PIPE ASSEMBLY
6- Insert the PVC Ø9 x Ø13 pipe in the PVC
Ø12 x Ø16 pipe and glue with Loctite (in the
Piccolo evaporator only*).
7- Insert the PVC pipes in the evaporator's run-
off pipe, and run to the outside (if necessary,
make a Ø22 borehole and install bushing).
Caution: Run-off pipes should have the descent
necessary to run off the water, avoiding any
loops or bottlenecks.
8- Cut the run-off pipes to the required size and
position the drainage valve. Secure with ties.
9- Make the gas load in accordance with the
table on page 27.
10- Once the equipment is loaded and checks
have been made for any leaks, mount the
anti-drip tape in the couplings and valve.
6
7
*
7
26
7
Desagüe
8
10
10