Publicidad
support@nextlevelracing.com
01
Align the holes on the Arm Rests with the threaded inserts on the bottom of the Seat Base. Bolt
through and secure with 8 x M8 25mm Bolts and Washers.
02
Align the mounting holes on the Seat Backrest with the mounting holes on the Seat Base recliner
plates. Bolt through and secure with 4 x M8 25mm Bolts and Washers.
PARTS:
• • 1 x Seat Base
• • 1 x Right Arm Rest
• • 1 x Left Arm Rest
• • 8 x M8 25mm Bolts and Washers
PARTS:
• • 1 x Seat Backrest
• • 4 x M8 25mm Bolts and Washers
6
03
Align the mounting holes on the Side Cover with the threaded hole on the recliner plate. Bolt through
and secure with 1 x M5 Screw. Once assembled insert Plastic Cap.
04
For the following steps it is recommended to lay the chair in a flat surface as shown in the picture to
get access to underneath the chair.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • Seat Covers
Repeat
on Other
Side
• • 2 x M5 Machine Screws
• • 2 x Plastic Caps
PARTS:
• • NIL
7
Publicidad
