Linking Two Speakers - ION Total PA Spartan Guia Del Usuario

Linking Two Speakers

To wirelessly link two Total PA
1. Power on both speakers using their Power Switches.
2. With no Bluetooth connected, press the Mode button on one Total PA
Bluetooth as the audio source, which appears as "bt" in the display. This will be the "secondary"
speaker.
3. Press the Link button on a second Total PA
"primary" speaker.
4. Wait up to 1 minute for the speakers to make the connection. Once the two speakers are linked,
press the Mode button on the "primary" speaker to select the desired audio source.
5. To disconnect, double-press the Link button on the "primary" speaker.
To link two Total PA
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a
power outlet.
2. Plug an XLR cable into the Mix Out located on the rear panel of one Total PA
This speaker (the primary) is the one to which you will connect audio sources such as a Bluetooth
device, microphone, or USB flash drive.
3. Plug the other end of the XLR cable into the XLR Input on the rear panel of your second Total
TM
PA Spartan speaker. This second speaker will receive the audio from any devices connected to
the first speaker (the primary).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the primary).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second
TM
Total PA Spartan speaker until the volume of this speaker matches the volume of the first
speaker (the primary).
TM
Spartan speakers:
TM
Spartan speakers using cables:
TM
Spartan to enter Stereo Link Mode. This will be the
TM
Spartan to select
TM
Spartan speaker.
9