3TECH USC-6L Manual De Instrucciones página 19

2 On/O Button - On/O Switch
After powering on, the LED displays
ready with normal working status.
Press On/O button once and the cleaning starts. The cleaning stops when the timer
counts down to
On/O button.
3 Function Button - Functions (Degas / Normal)
Press Function button,
O button to start degassing.,
normal cleaning function. Pressing Function button before it ends will stop degassing.
If additional degassing is needed after it ends, press Function button again.
Degas
When cleaning heavily soiled or greasy items or silver, copper or brass items, chemical
solutions need to be added into the water. The solution may form many small droplets
and take a long time to dissolve in the water. Newly added water may generate many air
bubbles on the tank walls. These will reduce the cleaning e ect in the beginning phase of
ultrasonic cleaning. Turning on the degas function will dissipate the droplets and the air
bubbles, usually in 2 minutes, and improve cleaning e ciency.
4 — Degas Status
Illuminated, the degas function is selected.,
5 — Normal Cleaning Status
Illuminated, normal cleaning is underway.
6 — Heater Status
Press TC button,
dims, indicating the heater is turned o .
7 Actual – Water temperature display. It displays the actual water temperature in the tank.
8
Digital LED display of working time. It counts down after work is started.
9 Set – Set temperature display. Press Temp button to select one of the 5 set
temperatures.
10 Time button — Timer quick set button. Press Time button, LED display shows
Each pressing increases it by 5 minutes
11 Button
— Timer decreasing button. Each pressing reduces the timer by 1 minute.
12 TC button — Heater button. Pressing TC button,
turned on. To cancel heating, press TC.
When the water reaches the set temperature 60ºC (140ºF), the heater will turn o
automatically.
13 Temp button – Temperature set button. 5 set temperatures can be selected. The
default temperature is 40ºC. Press Temp button to select the temperature in the
following sequence:
18
. If the unit needs to be stopped before the timer runs up, press
illuminates, indicating Degas function is selected. Press On/
will fl ash for 2 minutes, then the unit will return to the
fl ashes, indicating the heater is turned on. Press TC button again,
dims, indicating the heater is turned o .
which is the default time and the unit is
— Flashing, degassing is underway.
fl ashes, indicating the heater is
.