Care And Maintenance - 3TECH USC-6L Manual De Instrucciones

10.

CARE AND MAINTENANCE

1
2
3
22
Select one of the four cleaning methods recomm- ended
4
earlier.
1. When the heater is needed, press TEMP button to
select one of the 5 preset temperatures. Press TC
button, fl ashes, indicating the heater is turned on.
LED Actual displays actual water temperature. When
the water reaches the set temperature,
indicating the heater is turned o .
To ensure safety, the unit is designed with dual
protections. The heater will be turned o automatically if
it has been running for 50 minutes.
2. To speed up the mixing and to use less solution, use
degas function. Press TIME button to set the timer to
10 minutes then press Function button,
Press On/O to start degassing. It changes over to
normal cleaning automatically after 2 minutes.
3. When debris "smoke" is no longer visible, cleaning is
done. If additional cleaning is needed, reset the timer
and repeat the steps above.
When cleaning is completed, unplug the power cord,
5
open the lid and retrieve the basket and the items.
Connect the hose to the drainage pipe as shown
beforehand. Open the drainage valve to drain the dirty
water. Clean and wipe the tank dry. Close the drainage
valve.
Do not turn on the unit without water in the tank.
Even though the unit is designed with multiple protections,
if it is turned on for over 15 seconds without water in the
tank, it may damage the unit or severely reduce the life of
the unit.
Do not run the unit for extended time or continuously.
The unit is designed with overheat protection. If the unit has
been running for 45 minutes, it is recommended to stop the
unit for about 20 minutes to prolong its life.
Do not keep water in the cleaning tank for a long time.
After cleaning is completed, open the drainage valve to
drain the dirty water. Clean and wipe the tank dry.
dims,
illuminates.