Start-up and use
! The position of the corresponding gas burner is shown
on every knob.
Gas burners
Each burner can be adjusted to one of the following settings
using the corresponding control knob:
Maximum
Minimum
To turn on one of the burners, place a lighted match or lighter
near the burner, press the knob all the way in and turn it anti-
clockwise to the "High" setting.
The knob must be pressed in for about 2-3 seconds until the
into the control knob. If this is the case, the ignitor is present. To
light a burner, simply press the corresponding knob all the way
in and then turn it anti-clockwise to the "High" setting, keeping
it pressed in until the burner lights.
!
knob and wait for at least 1 minute before trying to relight it.
To switch off the burner, turn the knob in a clockwise
Practical advice on using the burners
the cookware.
the knob to minimum.
Burner
Fast (R)
Semi Fast (S)
Auxiliary (A)
To identify the type of burner, refer to the designs in the
! Make sure the pans do not overlap the edges of the hob
while it is being used..
Ø Cookware Diameter (cm)
24 - 26
16 - 20
10 - 14
Correct positioning of the FTGH burners
Precautions and tips
! This appliance has been designed and manufactured
in compliance with international safety standards. The
following warnings are provided for safety reasons and
must be read carefully.
General safety
follow the instructions provided in the paragraph on
"Positioning" the appliance.
whose symbols appear in the manual and on the
serial number plate.
home and is not intended for commercial or industrial use.
covered areas. It is extremely dangerous to leave the
appliance exposed to rain and storms.
damp hands and feet.
outlined in this booklet. Any other use of the appliance
(e.g. for heating the room) constitutes improper use and
is dangerous. The manufacturer may not be held liable
unreasonable use of the appliance.
must never be covered.
when the appliance is not in use.
GB
" position
27