Further Safety Instructions - Parkside PDOS 200 B2 Traduction Des Instructions Originales

G B I E
- Follow instruction for lubricating and
changing accessories.
- Inspect tool cords periodically and if
damaged have them repaired by an
authorized service facility.
and replace if damaged.
- Keep handles dry, clean and free
from oil and grease.
Disconnect tools. When not in use,
•
before servicing and when changing
accessories disconnect tools from the
power supply. Such preventive safety
measures reduce the risk of starting the
power tool accidentaIly.
Remove adjusting keys and
•
wrenches. Form the habit of checking
to see that keys and adjusting wrenches
are removed from the tool before turn-
ing it on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
Avoid unintentional starting.
•
Ensure switch is in "off" position when
plugging in.
Use outdoor extension leads.
•
When the tool is used outdoors, use
door use and so marked.
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while you are
alcohol or medication. A moment of
inattention white operating power tools
may result in serious personal injury.
Check damaged parts.
•
This will ensure that the safety of the
power tool is maintained.
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
2 4
All manuals and user guides at all-guides.com
-
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
- Do not use the tool if the switch does
not turn it on and off. Have defective
switches replaced by an authorized
service centre. There is a risk of injury.
Warning. The use of any accessory
•
or attachment other than one recom-
mended in this instruction manual may
present a risk of personal injury.
Have your tool repaired by a
•
qualified person. This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
parts, otherwise this may result in con-
siderable danger to the user.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
cable away from the grinding disc.
In the event that it is damaged or sev-
ered, immediately disconnect the plug
from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• The replacement of the plug or the con-
by the manufacturer of the electric tool
or his/her customer service in order to
avoid any hazards.