Ego Power+ ST1400E-ST Manual Del Operador página 12

EN
PROBLEM
Cracks on the
trimmer head or the
spool retainer comes
loose from spool
base.
The cutting line
cannot be wound
into the trimmer
head properly.
The cutting line
cannot be passed
through the trimmer
head when inserting
the line.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
12
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1400E-ST
CAUSE
◾
The trimmer head is worn out.
◾
The nut that locks the trimmer
head is loose.
◾
The cutting line is too long.
◾
Grass debris or dirt has
accumulated in the trimmer head
and blocked the movement of
line spool.
◾
Motor is overheated due to
repeatedly operating the line
winding system.
◾
Low battery
◾
The cutting line is split or bent
at the end.
◾
The lower cover is not released to
position after reinstalling.
SOLUTION
◾
Replace the trimmer head immediately; follow the
section "TRIMMER HEAD REPLACEMENT" in this
manual.
◾
Open the trimmer head and use an impact wrench
to tighten the nut.
◾
Cut the line so that about 13 cm long is showing on
each side.
◾
Remove the battery, open the trimmer head and
clean it thoroughly.
◾
Let the string trimmer work under no load for a few
minutes to cool the motor, then try to reload the line.
◾
Charge the battery.
◾
Cut the worn end of line and reinsert.
◾
Attach the battery pack onto the trimmer; press the
line loading button to briefly start the power loading
to release the lower cover.