Electrical Installation - Kingfisher BH60SS Manual De Instrucciones

• Do not use the hood if it shows signs of damage or imperfection.
Contact customer services for assistance.
• The manufacturer declines all liability for personal or material
damage as a result of misuse or incorrect installation of this
appliance.
• The appliance is for domestic use only as an extractor hood.

Electrical Installation

All installation must be carried out by a competent person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
The appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum
opening of 3mm between the contacts.
The installer must ensure that the correct electrical connection has been made and that it complies with the
wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be
replaced by a special cord or assembly available from the manufacturer or its service agent.
WARNING: THIS IS A CLASS I APPLIANCE AND MUST BE EARTHED
This appliance is supplied with a 3 core mains cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
This appliance should be connected directly to the consumer unit with a 3 Amp Residual Current
Device (RCD) protecting its circuit.
To avoid the risks that are always present when you use an electrical appliance it is important that this
appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for future reference and pass it on to any future owners. After
unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but
contact Customer Services.
The manufacturer declines all liability for damage caused to persons and objects due to incorrect or
improper installation of the appliance. Any permanent electrical installation must comply with the latest
wiring regulations applicable to your country and for your own safety a qualified electrician or contractor
should undertake the electrical installation.
The appliance is supplied from the factory to use external ducting (not supplied). Should you wish to use this
in recirculation mode only, please fit the correct carbon filter (not supplied).
5059340445861_MNL_IN_V04.indb 8 5059340445861_MNL_IN_V04.indb 8
8
12/7/2022 11:51 PM 12/7/2022 11:51 PM