Philips HB170 Manual De Instrucciones página 6

General description (fig. 1)
A
Tube lamps (type Philips Cleo 15 W)
with starters (type Philips S2)
B
Reflectors
C
Timer
D
Ventilation openings
E
Mains cord
F
Protective eye goggles (2x)
o o
(Type n . HB 071 / service n . 4822 690 80123 - illustrated - or
o o
type n HB 072 / service n . 4822 690 80147 - not illustrated - )
How to use the face tanner
- Insert the plug into a wall socket (220-240 V).
- Refer to the table in these instructions for use and your own
notes to determine the duration of the session.
- Put on the supplied protective goggles (F).
- Set the timer (C) to the session time.
- Position yourself in front of the face tanner. The distance
between your face and the tube lamps should be about
10 cm (= 4") (fig. 2).
- Once the set time has elapsed, the timer will switch off the
appliance automatically.
- Remove the plug from the wall socket after use.
After the UV tanning session
- Remove the plug from the wall socket.
- Note down the total of sessions on paper.
Cleaning
Always unplug the face tanner and let it cool down before
cleaning.
• You can clean the outside of the face tanner with a damp
cloth. Make sure that no water runs into the appliance.
• Do not use abrasives or scourers, or liquids such as petrol or
acetone.
Replacing the tube lamps and/or starters
In the course of time (in normal family use after some years)
the efficiency of the tube lamps will gradually decrease.
If this happens, you may increase the tanning session time or
have the tube lamps (and if required the starters) replaced.
Have the tube lamps and starters replaced only by
authorized service personnel: only these have the
required skill and dispose of the original replacement
parts.
The lamps of solariums contain substances which may
f pollute the environment. When discarding lamps,
please ensure that they are separated from the normal
household refuse and that they are disposed of at an
officially assigned place.
All manuals and user guides at all-guides.com
6
For U.K. only:
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp. plug.
Should you need to replace the plug, connect the wires as
follows:
Brown wire to the Live (L) terminal of the new plug.
Blue wire to the Neutral (N) terminal of the new plug.
Always fit the same value of fuse as that originally supplied
with your appliance.
Only use BS 1362 approved fuses.
As a guide only: Appliances under 700 W can have a 3 Amp.
fuse (red) and all others should have a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the moulded type
which has been cut from the mains cord) always remove the
fuse as the plug could be dangerous if ever inserted in a live
socket.