Publicidad
Idiomas disponibles
Idiomas disponibles
Power
This button will not only put the fireplace insert in a standby mode, but also you can see the flame
effect through the screen. This will turn off all functions at once.
Timer
Pressing the timer button repeatedly will cycle through the following timer.
Settings: 30 minutes, 1 hour, 2 hours, 3 hours, 4 hours, 5 hours, 6 hours and off.
The display shows: 30-1H-2H-3H-4H-5H-6H-None.
The fireplace will automatically turn off when the timer reaches zero minute.
Flame
This button controls the flame effect. Allows you to adjust the flame to suit your mood.
Press this button to increase/decrease the flame effect.
Change the flame by pressing flame button repeatedly.
The brightness level of flame is as follows: high-medium-low -off. And the display shows L3 -L2- L1
accordingly.
Heater
The default setting temperature is 72°F (22°C).
Hold the heater button for 5 seconds the display will flash, then change temperature by pressing
heater button repeatedly.
The thermostat setting range is 62°-82°F or 17°-27°C.
To change between °F and °C press and hold the Power button for 5 seconds when the heater is on.
After setting, the display unit will flash 5 times.
Weekly timer
Use the TIMER button to turn on the weekly timer.
Plus
Time and temperature increase during weekly timer setting.
Minus
Time and temperature decrease during weekly timer setting.
UK-6
Publicidad
