Operation Instructions; Maintenance; Storage; Environmental Protection - Worx WX030 Manual Original

offer advice.
4. OPERATION INSTRUCTION
Note: Please read the instructions carefully
before use.
INSTALLATION AND OPERATION
1. INSTALLATION OF THE SOFT THIN BRUSH/FLAT
TOP BRUSH
Remove the soft thin brush/flat top brush from the
soft thin brush storage port/flat top brush storage
port, connect the vacuum tube and clamp it in place.
(See figure A)
2. START/STOP(SEE FIGURE B)
Press the on-off switch button to start the vacuum
cleaner operation, and press again to stop it.
WARNING: PLEASE KEEP THE AIR INTAKE
UNOBSTRUCTED, OTHERWISE IT MAY CAUSE
MOTOR OVERHEATING AND MAY DAMAGE THE
MACHINE.
3. DUST CUP CLEANING
Press the dusting button, and the bottom cover
of the dust cup will pop up automatically. Rotate
counterclockwise and take out the filter element of
the dust cup. (See Fig. C1, C2) Dump the dust and
8 garbage in the cup and filter element into the trash
can, and rinse the filter element of the dust cup with
clean water. After the filter element of the dust cup
dries naturally, rotate clockwise and lock the filter
element of the dust cup in place.
Warning: Do not use the machine without
installing the filter element of the dust cup.
When the suction of the machine obviously
decreases, it is necessary to clean up the
garbage in the dust cup in time.

5. MAINTENANCE

WARNING: Remove the battery before carrying out
any servicing or maintenance.
Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage
your power tool.
OPERATION INSTRUCTIONS FOR THE
ACCESSORIES
Flat top brush is suitable for dust removal from
inaccessible corners in the interior of the car, such as
the bottom of the seat, the side of the seat, the inside
of the door, the area around the driver's seat, the rear
Vacuum Cleaner
window, the trunk of the car, etc.
The soft thin brush can be used to clean most of the
cracks and corners of the car.
PRECAUTIONS WHEN USING THE MACHINE
Can not be used to absorb water;
Can not be washed in water;
Check the hoses regularly and stop using if there is
any damage.
When cleaning or maintaining, remove the battery
pack.

6. STORAGE

Clean the moulded plastic housing of the machine
using a soft brush and clean cloth. Do not use water,
solvents or polishes. Remove all debris, especially
from the motor cooling vents.
Store in a secure, dry place out of the reach of
children.
Do not place other objects on the product.
7. ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
EN